ISO 582-1995 pdf download – Rolling bearings – Chamfer dimensions – Maximum values.
1 Scope This International Standard specifies the maximum chamfer dimensions of metric series rolling bearings, for which boundary dimensions, including chamfer minimum dimensions, are given in other International Standards. Requirements for the maximum dimen- sions of the corresponding shaft and housing fillet radii are also given. It does not apply to chamfers, for which dimensions are not specified, or for which other dimensions are specified in other International Standards. 2 Normative references The following standards contain provisions which, through reference in this text, constitute provisions of this International Standard. At the time of publi- cation, the editions indicated were valid. All standards are subject to revision, and parties to agreements based on this International Standard are encouraged to investigate the possibility of applying the most re- cent editions of the standards indicated below. Members of IEC and IS0 maintain registers of cur- rently valid International Standards. IS0 15: 1981, Rolling bearings – Radial bearings – Boundary dimensions – General plan. IS0 104:1994, Rolling bearings – Thrust bearings – Boundary dimensions, general plan.
IS0 246: 1995, Rolling bearings – Cylindrical roller bearings, separate thrust collars – Boundary dimen- sions. IS0 355:1977, Rolling bearings – Metric tapered rol- ler bearings – Boundary dimensions and series des- igna tions. IS0 464:1995, Rolling bearings – Radial bearings with locating snap ring – Dimensions and tolerances. IS0 12043: 1995, Rolling bearings – Single-row cylin- drical roller bearings – Chamfer dimensions for loose-rib and non-rib sides. IS0 12044:1995, Rolling bearings – Single-row an- gular con tact ball bearings – Chamfer dimensions for outer ring non-thrust side. 3 Definitions For the purposes of this International Standard, the following definitions apply. 3.1 radial direction chamfer dimension (of a bearing ring or washer): The distance between the imaginary sharp ring or washer corner and the inter- section of the chamfer surface and the ring or washer face. 3.2 axial direction chamfer dimension (of a bear- ing ring or washer): The distance between the im- aginary sharp ring or washer corner and the intersection of the chamfer surface and the bore or outside cylindrical surface of the ring or washer.