ISO 603-5-1999 pdf download – Bonded abrasive products – Dimensions – Part 5: G ri nd i ng wheels for su rf ace g r inding/f ace grinding.
1 Scope This part of of IS0 603 specifies the nominal dimensions, in millimetres, of: – Type 2: Cemented or clamped cylinder wheel – Type 6: Straight cup wheel – Type 31 : Segments – Type 35: Cemented or clamped disc wheel – Type 36: Disc wheel with inserted nuts – Type 37: Cylinder wheel with inserted nuts These bonded abrasive products are intended to be used for surface grinding where the workpiece is secured to a reciprocating table that moves in a straight line. The workpiece and the grinding wheel are mechanically guided. 2 Normative references The following normative documents contain provisions which, through reference in this text, constitute provisions of this part of IS0 603. For dated references, subsequent amendments to, or revisions of, any of these publications do not apply. However, parties to agreements based on this part of IS0 603 are encouraged to investigate the possibility of applying the most recent editions of the normative documents indicated below. For undated references, the lates edition of the normative document referred to applies. Members of IS0 and IEC maintain registers of currently valid International Standards. IS0 525:1999, Bonded abrasive products – General requirements. IS0 61 03: 1 999, Bonded abrasive products – Static balancing of grinding wheels – Testing. IS0 13942:-’), Bonded abrasive products – Limit deviations and run-out tolerances.
5 Specifications
The specifications are left to the manufacture’s discretion, see IS0 525.
5.1 Tolerances
Limit deviations and run-out tolerances in accordance with IS0 13942.
5.2 Balancing
Balancing is in accordance with IS0 61 03.
5.3 Marking
Marking of bonded abrasive products is in accordance with IS0 525.