ISO 12671:2021 pdf download – Thermal spraying — Thermally sprayed coatings — Symbolic representation on drawings.
8 Instructions when using a separate parts’ list This clause applies when a component is represented by one or more drawings and a separate parts’ list. In such a case, the coating will be indicated on the drawing only by a position number (see Figure 6). Any instructions regarding the coating, such as the spraying process, coating thickness and its acceptable thickness deviation (especially if coatings consist of a bond and top coat), spray material, surface condition and post-treatments shall be defined in the parts’ list or by indicating a specific technical instruction (see Figure 6). 9 Instructions when the use of the spray process is protected by a patent If a coating process shall be applied but the use is protected by a patent (spraying procedure, spray material, process parameter, etc.), the trade name of this coating process may be indicated analogous to “Coating per special specification” (see Figure 7) as a supplementary symbol in the symbolic representation, or it may be defined via a position number in the pertinent parts’ list (see Figure 6). 10 Representation and dimensioning The area of a component to be coated shall be indicated by a broad dashed-dot-line outside the outline of the component on the drawing. Where necessary, the size and position of the range of coating shall be defined by means of dimensions and tolerances on the drawing. Areas that are allowed to be coated (e.g. outside the coating range) shall be indicated by a broad dashed line outside the component’s outline. Areas that are not accepted to be coated shall not be indicated (see Clause 11). The dimension that locates the coating in relation to the front face of the work piece shall appear on the drawing only. The dimensions of length and/or width shall appear on the drawing only. Whenever a post-treatment is applied, the indication of the roughness tolerances shall be mentioned corresponding to the pertinent standard on the drawing close to the dimension.