ISO 16417:2020 pdf download – Earth-moving machinery — Hydraulic breakers — Terminology and commercial specifications.
3.4.1 carrier operating mass mass of the carrier (3.1) in its most usual configuration as specified by the manufacturer, with the operator (75 kg), full fuel tank and all fluid systems (e.g. hydraulic oil, transmission oil, engine oil, engine coolant) at the levels specified by the manufacturer and, when applicable, with sprinkler water tanks half full [SOURCE: ISO 6016:2008, 3.2.1, modified — The term “carrier” has been added to the term being defined, and in the definition the term “base machine” has been replaced by “carrier” and “i.e.” replaced by “e.g.”; the abbreviated term “OM” and Notes 1 and 2 to entry have been removed.] 3.4.2 breaker operating mass total assembled mass, including the hydraulic breaker (3.3), mounting adapter (3.3.11) and mounting hardware, if applicable, and the tool (3.3.4) but excluding the hydraulic hose, the hydraulic tubing and mounting pins 3.4.3 breaker mass mass of hydraulic breaker (3.3) including the power cell (3.3.7) and the bracket (3.3.3) or the housing (3.3.6), but excluding the tool (3.3.4), hydraulic hoses, the mounting adapter (3.3.11), mounting hardware and mounting pins 3.5 Working condition 3.5.1 Hydraulic fluid 3.5.1.1 flow rate volume of hydraulic fluid supplied from the carrier (3.1) per unit of time 3.5.1.2 flow rate range permitted upper and lower flow rate (3.5.1.1) at the hydraulic breaker (3.3) inlet port Note 1 to entry: Determined under normal operating conditions according to the manufacturer specifications. 3.5.1.3 hydraulic fluid temperature range permitted upper and lower hydraulic fluid temperature limits at the hydraulic breaker (3.3) inlet port Note 1 to entry: Determined under normal operating conditions according to the manufacturer specifications. 3.5.2 Hydraulic pressure 3.5.2.1 operating pressure range permitted inlet operating pressure, measured as close to the hydraulic breaker (3.3) inlet port as possible Note 1 to entry: Determined under normal operating conditions according to the manufacturer’s specifications.
3.6.1 overall length L 1 distance from the tool (3.3.4) tip when retracted into the power cell (3.3.7) to the top of the hydraulic breaker (3.3) including the bracket (3.3.3) or the housing (3.3.6) but not including the mounting adapter (3.3.11) Note 1 to entry: See Figure 1. 3.6.2 overall length without tool L 2 overall length (3.6.1) excluding the tool (3.3.4) Note 1 to entry: See Figure 1. 3.6.3 overall width maximum width of the hydraulic breaker (3.3) including the bracket (3.3.3) or the housing (3.3.6) and mounting hardware, but not including the mounting adapter (3.3.1.1) Note 1 to entry: The overall width can be different at the top and the bottom dependent upon the design. 3.6.3.1 overall width, top W 1 overall width (3.6.3) near the top of the hydraulic breaker (3.3) Note 1 to entry: See Figure 1. 3.6.3.2 overall width, bottom W 2 overall width (3.6.3) near the bottom of the hydraulic breaker (3.3) Note 1 to entry: See Figure 1.