UL 1565-2013 pdf download – Positioning Devices.
1 .1 This standard applies to those metallic and nonmetallic devices used for positioning – which may include bundling and securing – or to a limited extent supporting cable, wire, conduit, or tubing of a wiring system in electrical installations, to reduce the risk of fire, electric shock, or injury to persons. This standard applies to, but is not limited to, cable clamps, cable and conduit clips, and non-raceway wiring ducts. 1 .2 These requirements do not apply to cable ties or cable tie accessories, coated electrical sleeving, extruded insulating tubing, metallic or nonmetallic raceways or woven flexible nonmetallic tubing (fiber loom) employed as mechanical protection for insulated wires or equipment covered by other standards or requirements. Note 1: Cable ties and cable tie accessories are covered in the Standard for Cable Ties for Electrical Installations, CAN/CSA-C22.2 No. 62275 or UL 62275. Note 2: Nonmetallic Mechanical Protective Tubing (NMPT) is covered in the Standard for Nonmetallic Mechanical Protective Tubing (NMPT), CSA C22.2 No. 227.3 or UL 1696. 1 .3 These requirements do not apply to any mechanical protection or electrical insulation that is provided by these devices. 1 .4 These requirements do not apply to hardware for the support of conduit, tubing, and cable from a building structure, such as hangers, staples, straps, and similar devices for installation in accordance with the National Electrical Code, NFPA 70, and the Canadian Electrical Code (CE Code) Part I. Note: Hardware for the support of conduit, tubing, and cable from a building structure such as hangers, staples, straps, and similar devices for installation in accordance with the National Electrical Code, NFPA 70, and the Canadian Electrical Code (CE Code) Part I are covered in the Standard for Hardware for the Support of Conduit, Tubing, and Cable, CSA C22.2 No. 18.4 or UL 2239.
7 Marking 7.1 General 7.1 .1 Unless otherwise indicated in Clause 7, all markings shall be placed on the positioning device or the smallest unit package in which the product is shipped. 7.1 .2 A positioning device shall have a distinctive marking identifying the company and either the type, category, or model designation. 7.1 .3 In Canada, there are two official languages, English and French. All markings required by this Standard may be in other languages to conform with the language requirements where the product is to be used. 7.1 .4 A positioning device other than wiring duct whose performance is dependent upon specific maximum and minimum mounting hole size, panel thickness, screw size, mounting orientation, maximum wire, cable, bundle, or tubing size, or other assembly techniques, or special precautions for installation, shall be marked to include this information. Alternatively, with respect to 7.1 .1 , this marking may be provided in the installation instructions shipped with the product.