UL 1682-2017 pdf download – Plugs, Receptacles, and Cable Connectors of the Pin and Sleeve Type.
2.18 RECEPTACLE (OUTLET) – A device that is intended to provide power to an inserted plug, and that is installed as a fixed outlet or on equipment. 2.19 SWITCHED RECEPTACLE – An outlet with an associated or integral switching device to disconnect the supply from the receptacle contacts. 2.20 TERMINAL – A conductive part provided on a contact for connecting a conductor. 2.21 TERMINAL, CRIMP TYPE – A terminal in which an electro-mechanical connection is made between the terminal lug and a conductor by compressing the lug onto the conductors. 2.22 TERMINAL, FIELD WIRING – A terminal to which power supply, load, control, or grounding/bonding connections will be made in the field when the device is installed. 2.23 TERMINAL, INSULATION-DISPLACEMENT – A terminal having a contacting member that forces the conductor insulation aside and presses against the side of the conductor to make contact. 2.24 TERMINAL, PIN-TYPE (INSULATION-PIERCING) – A terminal having a contact pin that punctures the conductor insulation to contact the current-carrying conductor. 2.25 TERMINAL, PRESSURE-WIRE – A terminal in which the conductor is clamped under a pressure plate or saddle by one or more screws or nuts. 2.26 TERMINAL, SET SCREW – A terminal in which the clamping pressure is applied by the end of the screw bearing directly on the conductor. 2.27 TERMINAL, WIRE-BINDING SCREW – A terminal in which the conductor is bent around the screw and is clamped directly under the head of the screw when it is tightened.
3.1 .4 Specific components are incomplete in construction features or restricted in performance capabilities. Such components are intended for use only under limited conditions, such as certain temperatures not exceeding specified limits, and shall be used only under those specific conditions. 3.1.5 For products intended for use in Canada, general requirements are given in CAN/CSA-C22.2 No. 0, General Requirements – Canadian Electrical Code, Part II. 3.2 Reference publications 3.2.1 Products covered by this standard shall comply with the reference installation codes and standards as appropriate for the country where the product is to be used. When the product is intended for use in more than one country, the product shall comply with the installation codes and standards for all countries where it is intended to be used. 3.2.2 Where reference is made to any Standards, such reference shall be considered to refer to the latest editions and revisions thereto available at the time of printing, unless otherwise specified.