UL 1691-2012 pdf download – Single Pole Locking-Type Separable Connectors.
3.1 .2 A component is not required to comply with a specific requirement that: a) Involves a feature or characteristic not required in the application of the component in the product covered by this Standard, or b) Is superseded by a requirement in this Standard. 3.1 .3 A component shall be used in accordance with its rating established for the intended conditions of use. 3.1 .4 Specific components are incomplete in construction features or restricted in performance capabilities. Such components are intended for use only under limited conditions, such as certain temperatures not exceeding specified limits, and shall be used only under those specific conditions. 3.2 Units of measurements 3.2.1 The values given in SI (metric) units shall be normative. Any other values given shall be for information purposes only. 4 Definitions 4.1 The following terms and definitions apply in this Standard. Attachment plug – a device consisting of a male contact and a housing, intended to be attached to one cable. Configuration, Locking-type – a configuration that requires a motion other than a straight push or pull or requires a deliberate mechanical action such as that required by a threaded collar, a cam, or a bayonet, to connect or separate it when used with its mating part. Cord connector – a device consisting of a female contact and a housing, intended to be attached to one cable and intended to supply electrical equipment. Contact – a conductive element in a wiring device that mates with a corresponding element to provide an electrical path.
Receptacle – see Outlet (Receptacle) Single pole separable connector – a device, either inlet, outlet, or cable-connected, for the connection of single conductor cables in the form of pin and sleeve configuration. Terminal – a conductive part provided for the attachment of a conductor to a wiring device. Terminal, Bar – a terminal which is intended to secure a cable lug or bar by means of a bolt or bolts. Terminal, Crimp – a terminal in which the conductor is inserted into a hole or cavity, and compressed by a tool, and permanently deformed to attach the conductor. Terminal, Double set screw – a terminal in which the conductor is inserted into a hole or cavity, where it is clamped under the shank of two set screws. The clamping pressure may be applied directly by the shank of the screws or through an intermediate clamping member or shim to which pressure is applied by the shank of the screws. Terminal, Set screw – a terminal in which the conductor is inserted into a hole or cavity, where it is clamped under the shank of a set screw. The clamping pressure may be applied directly by the shank of the screw or through an intermediate clamping member or shim to which pressure is applied by the shank of the screw. Terminal, Threaded stud – a terminal which is intended to secure a cable lug or bar by means of a nut or nuts.